The door lock secures the washer door shut during operation.
Maytag 5000 series washer door locked.
My maytag 5000 steamer washer is locked and i cannot open the door.
If nothing else works the washer door can be opened as follows.
You will hear the door click when it unlocks.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
01 door lock motor and switch assembly.
I will try and unlock it via the lower panel access.
You should then be able to open the washer door.
Pull the door lock mechanism out from behind the door support front plate.
The machine was moved to put down a new floor.
The washer door will not open.
I pulled the panel at the bottom and was able to open the door but as soon as i close it again it locks and the light stays on.
If the door lock is defective the washer door will not latch properly.
The door will not immediately unlock while the cycle is running due to a possible high water level in the washer high water temperature tumbling or spinning.
When reinstalling the door lock replace the electrical shock hazard wire ties through the two standoffs on the disconnect power before servicing.
My maytag series 2000 front loader washer made a loud bang the other night and the machine was unplugged but the door remained locked.
I removed all the water by opening the cleanout behind the bottom panel but this light still stays on.
What code is e2 f3 flashing on machine.
Door lock door lock 4.
Carefully reach up along the inside of that front panel and pull down on the manual release tab that is on the bottom of the door latch assembly.
Check your home s fuses circuit breakers.
It was off this a m.
It may take up to five minutes for the washer to stop spinning and draining before the door will unlock.
First check that there is no water left in the machine.
Maytag 5000 series with steam washer door remains locked.
None of the adjustment lites were on.
My maytag washer goes through it s normal wash cycle but when it is supposed to stop it just keeps going through it s extra spin cycle.
At some point i can t remember it was making noise like it was preparing to or was spinning.
Maytag washer door or lid won t lock.
But the door locked lite was on.
Check that the main power switch is on.
The washer door cannot be opened with the key button if power is off.
Once the washer door is closed the washer can begin operating.
Clip the two wire ties that secure the wire harness to the door lock assembly.
I put a small load in last nite and went to bed.
