Looking at your use and care guide page 31 trouble shooting i have held read more.
Maytag front load washer door lock light flashing.
The control lock on bottom right is solid red.
Select drain spin to remove any water remaining in the washer.
I do not lid lock light flashing blinking on top load washing machine how to clear read more.
If the control locked light will not turn off i recommend unplugging the washer for 5 minutes.
If f8 e1 or lf too long to fill appears in the display the washer is taking too long to fill or the washer is filling and draining.
The lid lock light is flashing on my top load washer.
Plug the unit back in and see if the controls will respond.
Fresh hold option is on.
The door remains locked during this time.
I have an older kenmore top loading washing machine.
Scan the included wiring diagram until you find the wires labelled lid switch and lock switch the majority of washing machine lid lock switches are powered by 3 or 4 wires each of which performs a different function.
I have a control lock on my front load washer.
It is flashing red door locked.
While this option is on the fan blows and the load is tumbled periodically for up to 12 hours.
Nothing else will appear to be happening with the machine during this time.
To unlock the controls press and hold the cycle end signal for 3 deliberate seconds or until the control lock light goes out.
It s possible the drain hose extends more than 4 5 114 mm into the standpipe.
After 8 minutes the door will unlock.
Front loading washers include a control lock feature that temporarily disables use of the control panel and requires deactivating the lock prior.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
The washer door will unlock at the end of the drain.
When the lock light is blinking it typically means that the unit either took to long to fill with water in which case it ll go into flood mode and keep draining for 15 20 minutes and unlock on it s own or there is a glitch in.
The washer will go into a hold and drain routine for 8 minutes.
The door should unlock after 60 seconds.
I did some google searching and found that there could be a few different issues that are causing the lid lock light to flash or blink on the control panel of my washer.
Water remaining in washer after cycle.
The door lock led light will blink.
My maytag front load washer has a blinking door locked and the door will not open up.
Maytag front load washer door locked at install.
Examine your washer s tech sheet to determine which wires to cut.
