Fortrezz say the hardware is goo it is a device handler problem.
Mimolite smartthings garage door.
Does anyone have the actual device code for the mimolite garage door controller.
In the things menu i can read the current door status as well as open and close the door.
I was hoping to make changes to how this works for my case as i want it to control a gate.
I have a regular sears door opener with a button that either opens or closes the door.
The mimolite is not supported by smartthings.
I would like to use a mimolite to open close and provide the status of a garage door via smartthings.
Flow meter guide with smartthings.
Mimolite comes in a plastic enclosure for indoor use only.
Dantheman2865 committed nov 2.
Had issues with it reporting wrong garage door status on the phone app.
Got stuck between the two and finally gave up and returned the product.
The mimolite module is an interface bridge module capable of converting a digital or analog voltage input and or a z wavetm rf message input to a dry contact relay output and or a z wavetm rf message output.
In the routine.
If i go to the ide and add a device by selecting from template and then select mimolite garage door controller the code doesn t load or show up like other devices.
Smartthings say the device handler is not supported.
I have a set up a mimolite to open and close a garage door.
I have mimolite garage door controller set as the device type.
Flow meter guide with homeseer.
Mimolite wiring diagram for apollo gate opener.
Contribute to fortrezz smartthings development by creating an account on github.
Mb323 i wish i would have seen this thread earlier because i wrote one a long time ago that i ve been using that i could have shared it uses the magnetic contact similar to post 3 above and it also notifies if when the mimolite looses power.
Connect one wired devices.
This worked find except sometimes the close open event would get missed.
Make future change here.
So i was hoping to change the icons and.
I have added this device handler to my ide.
Initially i got the solution that johnconstantelo developed working with a magnetic switch that triggered when the door closed.
So far this is what i ve done.
The mimolite garage door device type will allow me to open and control the garage door in the things section although the state is not correct and the configure button does nothing.
Mimo2 installation instructions.
A switch on the door tells mimolite the current door status open or closed.
Based on todd wackford s mimolite garage door opener metadata automatically generated.
In doors and locks i can get it to show me the correct state i m just using a smartthings open close sensor however tapping the button does nothing.
The tile in my device type actuates the mimolite to open close the door but it doesn t reflect the state of the door so i created a virtual.
Mimolite wiring diagram for garage door application.
Mimolite installation instructions for vera controllers.
Mimolite installation guide for smartthings.
